How to install a compressor switch

Tools needed:
● Snap ring pliers (gpd 5811254)
● Switch puller/installation tool (gpd 5811423)

1. Loosen the manifold plate to release the pressure.(***Always wear safety glasses!***)
 

2. Insert switch into the switch installation tool.
 

​3. Place switch into switch port and press firmly.
 
 

---

4. Insert snap ring and press around the edges. Ensure that the snap ring seats correctly into the switch port. (Use caution when installing snap ring)
 

​5. Always check  the label on the side of the compressor for the correct amount of oil needed in the compressor. Check the oil using the drain plug on the side of the compressor.

How to remove compressor switch

Tools needed:
● Snap ring pliers (gpd # 5811254)
● Switch puller/installation tool (gpd # 5811423)
 

1. Loosen the manifold plate to release the pressure. (Always wear safety glasses!)                                                          

35_compressor_switch_installation_and_removal.pdf
File Size:	500 kb
File Type:	pdf

Download File

---

2. Squeeze snap ring that is holding the plug in place.

3.Gentle squeeze snap ring & pull up & out to remove,(Caution! Snap ring may fly off due to tension.)

---

​4. Pry up on the plug to remove.
 

Click "Download File" for the PDF version.